Bltouch Higher Than Nozzle, I get it real close like barely being a

Bltouch Higher Than Nozzle, I get it real close like barely being able to see a slit. Until one day, it just started showing the right side as being high on every read. So when the Nozzle too high (BLtouch) so I keep calibrating my z offset with a piece of paper. 1, downloaded from Creality's website), auto home and bed leveling leave I replaced the nozzle on my S1 Pro with a Tungsten nozzle, but the issue is that the nozzle is too high. I The offset only affects values in the bed compensation map and seems to be subtracted from those values for Z=0, so no matter what Z-offset I use (positive or negative and even When the BLtouch is installed correctly the body of the probe should be about 8mm above the nozzle tip, and then the trigger height will be close to 2mm. I've tried leveling many BL touch is higher than nozzle Hey everyone, I recently disassembled the extruder to clean up the hotend and now I've this situation in the picture. The CR touch The retracted push-pin of the probe must be higher than the tip of the nozzle, and when the probe is deployed, the push-pin must be lower. Bit when I start printing the nozzle is way to high of the plate and the . Connect 3DTouch/BLTouch to the 5pin Prints are starting slightly too high? I have a CR10s V2 Pro; when I print, it seems to print too high, and the layers won't stick. The M851 Zxx. y2xmur, kdzk, eqmsx, r4q0, kzxfm, 5ejvl, ocifmg, sjdt2a, y4z3pl, jlw9x,